Service for gas fireplaces in Andrews, FL

Each repair begins at the switch and follows the maker's manual. Free inspection for gas fireplaces in Andrews.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

A fireplace that's hard to get parts for

Heard that parts for your older gas fireplace are hard to find? Our pros start by reading the rating plate for the maker and model, then look up the listed replacement parts.

Many parts, like sensors, igniters and gaskets, are still available or have listed substitutes from the maker. When a key part, like the valve or the firebox, is no longer made, they'll tell you and price a replacement unit alongside the repair, so you can decide. Where both make sense, you choose. Reserve a parts check for your older gas fireplace in Andrews by calling (352) 675-6366.

We cover Andrews along with the rest of our Levy County area. In 2020, the Census Bureau counted 837 people living in Andrews.

What's Included

Switch, sensors, valve and glass

Logs reset to the maker's diagram
Barrier screens checked or added where offered
Vent leaks and pitch problems corrected
Water-damaged controls replaced before use

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Power outages and electronic ignition

If a storm knocks out power to your home in Andrews, a gas fireplace with electronic ignition may need battery backup to light. Weak backup batteries are a common reason it won't start when you need it. Our pros check the battery pack and receiver batteries on every service and show you how the manual says to light the unit during an outage.

How It Works

Tested before any part is swapped

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Gas fireplaces repaired to the manual in Andrews

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Your unit's own manual guides the repair, from the troubleshooting chart to the log diagram.

Your price, upfrontYou see the fault and the price for your gas fireplace in Andrews before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

Reading the pilot flame

The pilot flame has a job: it has to wrap the thermocouple and thermopile and reach across to the main burner. Makers show the right flame in a diagram in the manual, and a weak, lazy or misdirected pilot causes a lot of lighting trouble.

Dust, lint and spider webs in the pilot orifice or the pilot hood shrink or bend the flame. Our specialists clean the pilot assembly, check the flame against the diagram and adjust what the manual allows.

Once the flame looks the way the maker drew it, the sensors get their heat and the unit lights reliably.

Why the glass has to seal

On a sealed gas fireplace, the glass front closes off the combustion chamber as well as showing the flame. Maker manuals warn that the glass must be properly seated and sealed, or combustion products can leak into the room, and that the unit mustn't run with the glass removed, cracked or broken.

Latches, frame and the gasket that seals the glass to the firebox all get checked. A flattened or torn gasket is replaced with the maker's part, and cracked glass is replaced before the unit runs again.

It's one of the checks on every service visit. A clean, tight seal also keeps the glass clearer.

Inside the yearly gas fireplace service

Manuals for gas fireplaces call for a yearly check by a qualified service person, and each lists what to look at. Our pros work from your unit's list, which covers cleaning the burner, pilot and control compartment, and checking the flame against the manual's picture.

They test the sensors or ignition, look at the glass gasket and latches, and check the vent and termination for damage, blockage and loose joints. Logs and embers are placed to the layout.

Keep the appliance manual and any earlier service paperwork together. They help you discuss recurring symptoms and review which parts or adjustments have already been tried. Proposed repairs come with a written estimate, so a service visit does not leave you guessing about the next cost.

Free Inspection

Your gas unit, tested free

Shape of the pilot flame against the manual's drawing
Thermocouple and thermopile readings taken at the gas valve
The safety barrier in front of the glass, and its condition
Spill switch on units vented through a chimney

Claim 10% off your first service

Warm evenings again in Andrews? Arrange a visit and a first service call is 10% off.

Call (352) 675-6366 Get a Free Inspection

FAQs

Gas fireplace fixes, answered

Is the ticking noise normal?

Steel fireplaces tick and pop as they heat and cool, and makers call that normal. A new rattle, grinding or loud bang on lighting isn't, and our specialists can check it.

Do gas fireplaces need yearly service?

Follow the service interval in your appliance's manual. Our pros can discuss that model's checks and any symptoms you've noticed before arranging the visit.

Our Services