Fixing gas fireplaces for homes in Jonesville

Clicking but no flame? Book a free inspection in Jonesville and get the ignition fault found and fixed.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

A fireplace that's hard to get parts for

Heard that parts for your older gas fireplace are hard to find? Our pros start by reading the rating plate for the maker and model, then look up the listed replacement parts.

Many parts, like sensors, igniters and gaskets, are still available or have listed substitutes from the maker. When a key part, like the valve or the firebox, is no longer made, they'll tell you and price a replacement unit alongside the repair, so you can decide. Where both make sense, you choose. Reserve a parts check for your older gas fireplace in Jonesville by calling (352) 675-6366.

About 10 miles, measured point to point, lie between Jonesville and the Gainesville reference point. Our specialists serve Jonesville as part of Alachua County.

What's Included

Repairs made with the maker's parts

Pilots that drop out diagnosed with a meter
Electronic ignition faults traced and reset
Logs reset to the maker's diagram
Annual service for gas fireplaces in Jonesville

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Lint and pet hair in Jonesville

Dust, lint and pet hair are the day-to-day enemies of a gas fireplace in Jonesville. They drift into the burner, the pilot and the air openings, and the flame changes. Our pros clean those areas on every service, following the maker's advice to check sooner in homes with pets. A clean burner can clear up a flame complaint with no parts at all.

How It Works

Switch first, flame last

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Working from your unit's manual

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Service follows your appliance's instructions, with proposed repairs priced upfront.

Your price, upfrontYou see the fault and the price for your gas fireplace in Jonesville before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

Electronic ignition faults

Plenty of newer gas fireplaces light with a spark instead of a standing pilot. A module sends a spark across a gap to light the pilot or burner, and a flame sensor confirms the flame. If the sensor doesn't see it, the module locks out after a few tries.

The maker's troubleshooting flow chart walks through the spark gap, the ceramic insulator, the ignition cable and the flame sensor, which should sit in a steady blue flame.

Following that chart, our pros fix what's wrong and reset the module the way the manual describes. Batteries in any backup pack are checked too.

Which noises are normal

Steel fireplaces tick and pop as they heat and cool, and makers mention it in their manuals as normal. A soft whoosh when the burner lights is normal too.

A rattle from the glass, a grinding blower, a loud bang on ignition or a new whistle isn't. A delayed ignition bang, where gas builds up before it lights, needs looking at soon.

Our specialists listen to the unit through a full cycle with you, from lighting to shutdown, and tell you which sounds belong and which point to a part that needs work. Each fix is priced before anything is replaced.

CO alarms near a gas unit

Any gas appliance can produce carbon monoxide when something is wrong, and an alarm is how you'd know, since the gas has no smell. Makers list early symptoms of exposure, such as headaches, dizziness and nausea, and advise getting fresh air.

If a CO alarm is sounding, get everyone outdoors, then call 911 from outside.

On every service, our pros check the glass seal, the vent and the flame, the parts that keep combustion gases where they belong, and suggest testing the alarms near the fireplace and bedrooms while the visit is underway. Alarms are cheap, and they work.

Free Inspection

What we test on a gas unit in Jonesville

Spill switch on units vented through a chimney
The blower, its temperature switch and the fan wheel
The rating plate, the model and which listed parts are still made
Anything that was under water, listed for replacement

Claim 10% off your first service

Pilot won't stay lit? Book your first repair today and claim a 10% discount.

Call (352) 675-6366 Get a Free Inspection

FAQs

What people ask when a gas unit acts up

Why won't my pilot stay lit?

The thermocouple or thermopile may be worn or out of the flame, or the pilot may be clogged. Our pros meter-test the sensors and check the pilot flame before replacing anything.

Is the ticking noise normal?

Steel fireplaces tick and pop as they heat and cool, and makers call that normal. A new rattle, grinding or loud bang on lighting isn't, and our specialists can check it.

Our Services