Stainless liners fitted in Evinston, FL

Sized to your appliance's listing, a liner keeps smoke and exhaust moving. Free inspection for chimneys in Evinston.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

Insulating the liner

Wondering if the liner needs insulation? Liner makers such as Selkirk require it where the chimney's clearance to combustibles can't be confirmed, and insulation also keeps the flue warmer, so smoke rises faster and leaves less deposit. On a chimney near framing, that protection matters most.

Our pros wrap the liner in a foil-faced ceramic blanket with overlapping seams, tape and a mesh sleeve, following the maker's instructions, or use a poured insulation where the liner maker allows it. The insulation choice goes on your quote with the reason for it. Reserve an insulated liner install in Evinston by dialing (352) 675-6366.

Service in Evinston is limited to its Alachua County portion. The community also extends into Marion County, which is outside this site's coverage.

For Evinston, this site covers the part in Alachua County. The Marion County portion is outside this service area. The sea coast does not form part of Evinston's boundary.

What's Included

Liner, insulation, connector and top plate

Insulation wrapped to the liner's listing
Top plates sealed and caps fitted
Fire-damaged flues relined
Break-in steps written out for homeowners in Evinston

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Steep roofs and liner installs

Relining happens from the top of the chimney, so roof access matters. On a steep or fragile roof in Evinston, our pros use roof brackets, ladders and extra protection to reach the chimney safely.

That setup is part of the quote, and it doesn't change the liner or how it's installed. Roof protection goes in place first. The same care goes on at every visit afterwards.

How It Works

Test piece first, then the full liner in Evinston

Read the appliance

The rating plate and manual come first, then the flue is measured and inspected.
Sweep and prove the path

After a sweep, a test piece is run down the flue to confirm the liner will pass.
Wrap, feed and connect

The liner is insulated where needed, fed down, and connected at the bottom.
Seal the top, explain break-in

The top plate and cap go on, the draft is checked, and you get break-in steps.

Why Choose Us

Chimney liners sized right in Evinston

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Insulation goes on exactly as the liner's listing calls for, named on your quote.

Your price, upfrontThe liner, insulation and install are priced up front, before anything is ordered for Evinston.
Our workmanship warrantyThe liner has its maker's warranty, and our workmanship warranty covers how we installed it.
Locally owned and operatedLocally owned, so the liner we install is one we can come back and sweep.

Call (352) 675-6366 Get a Free Inspection

Why the appliance sets the liner

A liner is part of the appliance's venting system, so the appliance's instructions and listing come first. They name the flue size, sometimes the liner type, and the clearances.

A wood insert might call for a full-length liner of a set diameter. A furnace's instructions point to sizing from the national gas code's venting tables. An open fireplace has its flue size set by the building code in relation to its opening.

Nothing gets measured until the appliance's rating plate and manual are read, so the liner that goes in is the one the appliance was tested with, with no size picked from memory.

The catch with oval liners

When a round liner is too big for a narrow rectangular flue, it can be pressed into an oval. But ovalizing changes the liner's area, and a liner that has lost too much area can't carry the appliance's exhaust.

Liner makers publish how much ovalizing their product allows. Our pros compare the oval size against the appliance's needs before choosing it. If an oval won't keep enough area, the options include a smaller appliance or removing the old tile to make room for a round liner.

You'll see the sizes and the reasoning on the quote, and no liner is forced into a flue that can't take it.

A tee fitting at the base of the liner

For some inserts, the liner connects to the appliance through a tee, a T-shaped fitting with a removable cap at its base. Liner makers include it so soot and debris that fall down the liner collect where they can be emptied.

Where the appliance and liner call for a tee, one goes in, and you'll be shown where its cap is. At each sweep the cap is opened and the debris emptied, which keeps the connection from clogging.

Where the setup uses a direct connection instead, you'll hear how that one is checked and cleaned. The cap is easy to reach.

Free Inspection

The free relining inspection, flue first

Type of appliance, its rating plate and its venting instructions
Condition of the clay tile and its joints
Fireplace opening measured against the flue size rule
Signs of condensation damage in flues that serve gas appliances

Claim 10% off your first service

A new liner, sized and insulated; first-time customers who reserve today claim a 10% discount.

Call (352) 675-6366 Get a Free Inspection

FAQs

Relining, answered in short

Is Evinston on your list for relining?

Yes. Our specialists reline chimneys throughout Alachua County, Evinston included, and every job opens with a free look at the flue and the appliance it serves. Knowing what vents into the chimney helps us come prepared.

Do you run the gas line on a conversion?

No, the gas line is a gas contractor's work. Our specialists handle the liner and venting, and your quote says who handles each part.

Our Services