Brick and mortar repairs for chimneys in Spring Ridge

Joints repointed, damaged brick replaced, mortar matched to your chimney. Free inspection for homes in Spring Ridge.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

A crack that splits the bricks themselves

Cracks that cut right through the bricks themselves, instead of following the joints, mean something stronger than weathering is at work. Rusting steel inside the wall, like an old lintel or tie, swells and splits the brick around it. So can a mortar harder than the brick, which forces movement into the units.

New brick in the same spot will crack again if the cause stays, so finding it comes before replacing anything. Rusting steel gets treated or replaced; over-hard mortar gets raked out. Each step is priced separately on the quote. Reserve a look at the cracked brick in Spring Ridge by phoning (352) 675-6366.

About 24 miles, measured point to point, lie between Spring Ridge and the Gainesville reference point. Our specialists serve Spring Ridge as part of Gilchrist County.

What's Included

Your chimney masonry, put right

Flaking bricks cut out and replaced
Stepped cracks traced to their cause and repaired
Brick cleaned without harsh acids
Joint profiles tooled to shed water in Spring Ridge

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Masonry on a chimney nobody uses

Brick on an unused chimney in Spring Ridge still stands in the rain and sun. Its joints wear and its brick weathers just the same. Our pros check idle chimneys as closely as busy ones, since loose masonry above the roof is a hazard whether the fireplace is used or not. Loose brick near the top gets checked first, since it can fall.

Our Process

Mortar matched before a joint is touched

Find which half failed

Every face is looked over for worn joints, damaged brick and cracks, and the cause is found.
Match mortar and brick

Samples are mixed and cured, and replacement brick is matched and shown to you.
Joints raked, then refilled

Joints are raked to sound depth, repointed in layers, and damaged brick is swapped out.
Cover, clean, cure

The work is covered against rain, the site cleaned, and you get curing time spelled out.

Why Choose Us

Patient, family-run masonry work

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

When repair stops making sense, you'll see it priced next to a rebuild.

100% satisfaction, guaranteedIf the repair doesn't blend in or hold, we make it right. That's our 100% satisfaction guarantee.
Your price, upfrontMasonry work in Spring Ridge is priced by section up front, so you can choose what gets done.
Locally owned and operatedA locally owned business, so the masons who repointed your chimney are easy to reach later.

Call (352) 675-6366 Get a Free Inspection

Why brick faces pop off

Spalled brick, with the face flaked off in a sheet, is water damage. As wet brick dries, dissolved salts can crystallize just below the surface instead of on it, and the pressure pushes the face away. The National Park Service's guidance on repointing historic masonry describes it, and notes that mortar harder or less permeable than the brick drives more moisture into the units.

Our pros replace spalled brick, but they also look for why it was wet. Fixing the water path, and using mortar that lets the wall breathe, keeps the new brick from going the same way. The source gets fixed alongside the brick.

When the wall bows out

A section of chimney that bulges outward has separated inside, with the outer brick pulling away from the masonry behind it. Water getting into the wall and rusting ties or steel are common reasons.

Measuring the bulge comes first, then tapping the brick for hollow areas and looking for fresh cracks around the edges that would mean it's still moving. A small, stable bulge can be taken down and relaid with new ties. A large or active one points to rebuilding that section. Until it's assessed, the area below should be kept clear. The repair plan and its price come on the quote once the cause is clear.

Letting new mortar cure

Mortar gains its strength by curing, and it needs moisture to do that. In hot sun or wind, a fresh joint can dry out before it has cured, leaving a weak, powdery surface that washes out.

Our specialists schedule work to avoid the harshest sun where they can, shade the work, and mist the joints lightly as they cure if the conditions call for it. Covering the work against rain protects it from the other direction. You'll hear if there's anything to watch for in the days after the repair, and when the chimney can be used. Rushing the cure is one of the reasons repointing fails early.

Free Inspection

Every face of the chimney, checked free in Spring Ridge

Cracks through the bricks and what's causing them
Earlier patches made with hard or mismatched mortar
Gap or cracking where the chimney meets the house wall
Paint or coatings on the brick and what's under them

Claim 10% off your first service

Discuss masonry work in Spring Ridge and take 10% off your first service.

Call (352) 675-6366 Get a Free Inspection

FAQs

What people ask about chimney brick

Can you clean the stains off my brick?

Yes, once the water causing them is fixed. Our pros avoid harsh acid cleaners that can burn brick and test gentler methods on a small area first.

Which parts of masonry work does the warranty cover?

The workmanship on the sections we repair, as named on your quote along with the mortar and brick used. If a joint we repointed fails, our pros return and fix it. Talk to us about the brick on your chimney in Spring Ridge at (352) 675-6366.

Our Services