Installing gas fireplaces for homes in Micanopy

Our pros coordinate the gas contractor, the electrician and the roofer in Micanopy, after a free planning visit.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

Homes that run on propane

A propane installation needs a fireplace approved for that fuel and a suitable supply arrangement. Any conversion requires the parts and procedure permitted for the particular model. The gas contractor can address the supply side while the fireplace proposal identifies the appliance and its installation needs.

Our specialists make sure the unit is set up for propane, and your propane supplier or a gas contractor handles the tank and the line. The quote names each part. If you're switching from natural gas to propane, or the other way, the conversion kit is fitted to the maker's instructions. Call our pros about a propane gas fireplace in Micanopy: (352) 675-6366.

Micanopy sits away from Florida's Gulf and Atlantic shoreline. Micanopy Historic District is found in Micanopy.

What's Included

Direct-vent units, fitted to the manual

Terminations placed to the clearance table
Mantel and facing plans checked against the chart
Gas line work coordinated with a gas contractor
Startup readings recorded for homes in Micanopy

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Permits for an inland install

Permits generally apply to a gas fireplace installation in Micanopy, and the local building department inspects the work. The gas contractor's line may carry its own permit. Our specialists plan around the inspections and put on the quote who pulls each permit and whether the fee is included. Timelines allow for the inspection schedule. The gas contractor's permit, if any, is noted separately.

Our Process

Vent route settled before the unit arrives

Trace the vent routes

Walls, attic and roof are measured against the vent tables and termination clearances.
Choose and plan

You pick a unit, and the plan covers framing, gas, power and every trade involved.
Install to the manual

The unit is set, the vent assembled and pitched, and the gas contractor connects the line.
First flame and a walkthrough

Leak test, pressures, logs and barrier are checked, and you're shown how to use it.

Why Choose Us

Every trade named on your quote

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Units in Micanopy are installed to their own manual, from framing to the barrier screen.

Your written price is freeEach unit that fits, with its vent route, is given its own price for free, side by side.
Locally owned and operatedYour installer is locally owned and can service the gas fireplace in Micanopy later on.
No hidden fees, all upfrontNo hidden fees: vent parts, framing checks and startup are all on the written price.

Call (352) 675-6366 Get a Free Inspection

Pitch on horizontal runs

The horizontal parts of a gas fireplace vent aren't laid dead level. Each system's manual sets how they're pitched, and the figure differs from one maker's system to another, which is why our pros read it for your unit instead of relying on habit.

A run pitched the wrong way can collect condensation or cause the flame to go out, a problem maker troubleshooting sections point to directly.

Our specialists set the pitch with a level as each section goes in and support the pipe at the spacing the manual calls for, so it stays put. The pitch is checked again before the finish goes on.

Heaters and decorative units

Two standards cover vented gas fireplaces in the fuel gas code: ANSI Z21.88 for vented gas fireplace heaters and ANSI Z21.50 for vented decorative gas fireplaces. A heater is built to warm the room efficiently; a decorative unit puts the look of the flame first.

Both can look beautiful, and both vent the same basic way. The difference is how much heat reaches you.

Our specialists ask how you'll use the fireplace and show you units of each kind that fit your room, with their heat ratings from the makers. Flame adjustments on some models let one unit serve both ways, and our pros will point those out.

Running a gas fireplace on propane

Natural gas or propane, a fireplace burns the one its rating plate names. A propane unit either leaves the factory set up for it or gets the maker's conversion kit, and propane tanks stay outdoors, as the manuals say. Some manuals set a minimum tank size for the unit.

Your propane supplier or a gas contractor handles the tank, the regulator and the line to the house.

Our specialists make sure the unit is set up for propane before it's installed, fit any conversion kit to the maker's instructions and set the pressures to the plate. The quote names each part of the job.

Free Inspection

Vent tables and clearances, checked in Micanopy

Attic and roof route for a vent that goes up instead
Vent rise, run and elbows against the maker's table
Framing dimensions and header height from the manual
Existing unit and vent when replacing an old fireplace

Claim 10% off your first service

Book your first install today and your new gas fireplace in Micanopy is 10% off.

Call (352) 675-6366 Get a Free Inspection

FAQs

Planning a gas fireplace? Ask us

Can it vent straight out the wall?

If the wall is an outside wall and the spot meets the maker's termination clearances, yes, and that's the simplest route. Otherwise, the vent can go up through the roof.

Can a gas fireplace go in a bedroom?

The fuel gas code limits it. Direct-vent units that take all their air from outside can go in a bedroom where their listing allows. Our pros check the room and the listing first.

Our Services