Trouble with the gas fireplace in Archer?

A gas fireplace that will not run properly deserves a model-specific check. Arrange a free inspection in Archer.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

A blower that hums or won't run

Fan that pushes warm air into the room silent, noisy or running nonstop? Blowers on gas fireplaces are controlled by a temperature switch or a control board, and their motors wear out over the years.

Switch, wiring and motor each get tested, and our pros clean the dust and pet hair that clog the fan. A worn motor is replaced with the maker's part. Getting the blower working again brings back a lot of the heat the fireplace was made to give. Chat with a local pro about the fireplace fan in Archer at (352) 675-6366.

Archer recorded a population of 1,140 in the 2020 Census. Archer is an inland service location, separate from the sea coast.

What's Included

Gas fireplace fixes our pros make in Archer

Electronic ignition faults traced and reset
Burners and pilots cleaned of lint and dust
Gas conversions done with the maker's kit
Fixes in Archer that our workmanship warranty stands behind

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Glass haze from occasional use

If glass on a gas fireplace in Archer becomes hazy, follow the model's cleaning instructions only once the appliance is off and cool. Persistent clouding, cracks or damaged seals need assessment before further use. Our pros discuss whether cleaning or an approved replacement is appropriate after checking the actual condition.

How It Works

Test first, replace second

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Gas fireplace pros who find the fault first

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Every reading, part number and price comes with the reasoning behind it.

Your price, upfrontYou see the fault and the price for your gas fireplace in Archer before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

Replacing the gas valve only when it's the cause

The gas valve is one of the costliest parts on a gas fireplace, and it tends to get blamed first. Maker troubleshooting charts put it last: the valve is replaced when the sensors read good and the switch circuit tests good, and the burner still won't come on.

With a meter at every step of that order, a valve is replaced only when the readings point to it.

When it is the valve, our pros fit the maker's listed replacement for your model and gas type, test it with a leak solution and set the pressures to the rating plate.

Vent problems that put the flame out

Direct-vent pipe is two pipes in one: an inner pipe carrying exhaust out and an outer one bringing fresh air in. If the inner pipe leaks, exhaust mixes into the fresh air and the pilot and burner can go out.

Maker troubleshooting sections also point to horizontal vent runs pitched the wrong way and termination caps installed incorrectly.

When a unit shuts down mid-burn, the vent joints, the pitch and the termination get checked against the manual. Fixing the vent fixes the outage, and any parts come from the vent maker's listed range for your system.

CO alarms near a gas unit

Any gas appliance can produce carbon monoxide when something is wrong, and an alarm is how you'd know, since the gas has no smell. Makers list early symptoms of exposure, such as headaches, dizziness and nausea, and advise getting fresh air.

If a CO alarm is sounding, get everyone outdoors, then call 911 from outside.

On every service, our pros check the glass seal, the vent and the flame, the parts that keep combustion gases where they belong, and suggest testing the alarms near the fireplace and bedrooms while the visit is underway. Alarms are cheap, and they work.

Free Inspection

Switch to vent, checked free

Wall switch, remote and receiver, plus the batteries in each
Glass, gasket and latches that seal the front
Vent joints, their pitch and the termination outside
The blower, its temperature switch and the fan wheel

Claim 10% off your first service

Serviced to the maker's manual, and a first visit is 10% off.

Call (352) 675-6366 Get a Free Inspection

FAQs

When the pilot, igniter or glass acts up

Smell gas near the fireplace?

Leave the switches and controls alone. Get everyone out, then phone 911 or your gas company once you're outside. Once they've made it safe, our specialists can inspect and repair the unit.

Why won't my pilot stay lit?

The thermocouple or thermopile may be worn or out of the flame, or the pilot may be clogged. Our pros meter-test the sensors and check the pilot flame before replacing anything.

Our Services