Fixing gas fireplaces for homes in Hampton

Pilots, ignition, valves and glass, repaired by family-run gas fireplace pros in Hampton. Inspecting costs you nothing.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

Getting ready for the first cool evening

Planning to use the gas fireplace when the evenings cool down? A service beforehand means it lights when you want it. Units that sit idle for months collect dust in the burner and pilot, and insects can nest in the small tubes.

A pre-season service cleans the burner and pilot, tests the ignition and sensors, looks at the vent and termination outside, and makes sure the glass seals. Small fixes are priced on the spot. If the vent or termination outside needs work, that's priced too, so the first cool evening goes the way you planned. Reserve a pre-season gas fireplace service in Hampton at (352) 675-6366.

The Gainesville reference point is roughly 18 miles from Hampton as the crow flies. In our service area, Hampton is grouped with Bradford County.

What's Included

Repairs made with the maker's parts

Electronic ignition faults traced and reset
Vent leaks and pitch problems corrected
Gas conversions done with the maker's kit
Water-damaged controls replaced before use

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Water leaks near the fireplace

A roof leak, a plumbing leak or a flood that reaches a gas fireplace in Hampton can damage its controls. Makers say not to use a unit if any part has been under water. Our specialists replace any control part the water reached with the maker's parts before the fireplace is used again. No part that was under water stays in the unit.

How It Works

Switch first, flame last

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Working from your unit's manual

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Every visit includes the glass seal and barrier screen, since they keep the room safe.

Your price, upfrontYou see the fault and the price for your gas fireplace in Hampton before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

Cleaning lint from the burner

Lint, dust and pet hair drift in and settle on the burner, in the air openings and in the control compartment. Makers call for keeping those areas clean and suggest checking sooner in homes with pets.

Clogged burner ports and air openings change the flame, making it yellow and sooty or weak and uneven. Our specialists vacuum and brush the burner, the ports, the pilot area and the control compartment during a service.

It's simple work, and it fixes a surprising number of flame complaints without any parts at all. It's part of every yearly service. The service summary notes what was found in the burner.

Vent problems that put the flame out

Direct-vent pipe is two pipes in one: an inner pipe carrying exhaust out and an outer one bringing fresh air in. If the inner pipe leaks, exhaust mixes into the fresh air and the pilot and burner can go out.

Maker troubleshooting sections also point to horizontal vent runs pitched the wrong way and termination caps installed incorrectly.

When a unit shuts down mid-burn, the vent joints, the pitch and the termination get checked against the manual. Fixing the vent fixes the outage, and any parts come from the vent maker's listed range for your system.

Fireplace blowers and their switches

Lots of gas fireplaces carry a blower that pushes warm air out into the room. It's switched on by a temperature switch that senses the firebox warming up, or by the control board on newer units.

When the blower won't start, the switch, the wiring or the motor can be the cause. When it's noisy, worn bearings or a fan caked in dust and hair are the likely suspects.

Our specialists test each part, clean the fan, and replace a worn motor or switch with the maker's part. A working blower sends a lot more of the fireplace's heat into the room.

Free Inspection

What we test on a gas unit in Hampton

Shape of the pilot flame against the manual's drawing
Vent joints, their pitch and the termination outside
The blower, its temperature switch and the fan wheel
Anything that was under water, listed for replacement

Claim 10% off your first service

Pilot won't stay lit? Book your first repair today and claim a 10% discount.

Call (352) 675-6366 Get a Free Inspection

FAQs

What people ask when a gas unit acts up

Does the valve need replacing?

Only if testing says so. Maker troubleshooting charts have the valve replaced last, after the sensors and switch test good, and our pros follow that order with a meter.

Is the ticking noise normal?

Steel fireplaces tick and pop as they heat and cool, and makers call that normal. A new rattle, grinding or loud bang on lighting isn't, and our specialists can check it.

Our Services