Service for gas fireplaces in Lake Butler, FL

Our specialists test first, and you pay only for the part that actually broke. Free inspection in Lake Butler.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

Clicking, then silence

Hear the igniter clicking away but the burner won't catch? On a unit with electronic ignition, the spark may be jumping the wrong gap, the ceramic insulator may be cracked, or the flame sensor may not see the flame, so the control locks out.

Spark gap, insulator, ignition wiring and flame sensor are tested against the maker's troubleshooting steps, and our pros reset the control once the fault is fixed. Batteries in a backup pack or receiver are checked too, along with the wiring connections at the module. Talk to our gas fireplace pros about the clicking unit in Lake Butler by calling (352) 675-6366.

A straight line from the Gainesville reference point to Lake Butler runs about 23 miles. Lake Butler is on our Union County list of places we serve.

What's Included

Switch, sensors, valve and glass

Pilots that drop out diagnosed with a meter
Glass gaskets replaced and fronts resealed
Gas conversions done with the maker's kit
Water-damaged controls replaced before use

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Renovation dust and a gas fireplace

Had work done in the room with the fireplace in your home in Lake Butler? Drywall and sanding dust settle in the burner and the control compartment and can clog the small openings. Our specialists clean the unit thoroughly after a renovation and check the flame and pilot before you use it again. A quick pre-use clean saves a service call later.

How It Works

Tested before any part is swapped

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Gas fireplaces repaired to the manual in Lake Butler

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

A local, family-run business that services the same fireplace year after year in Lake Butler.

Your price, upfrontYou see the fault and the price for your gas fireplace in Lake Butler before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

Electronic ignition faults

Plenty of newer gas fireplaces light with a spark instead of a standing pilot. A module sends a spark across a gap to light the pilot or burner, and a flame sensor confirms the flame. If the sensor doesn't see it, the module locks out after a few tries.

The maker's troubleshooting flow chart walks through the spark gap, the ceramic insulator, the ignition cable and the flame sensor, which should sit in a steady blue flame.

Following that chart, our pros fix what's wrong and reset the module the way the manual describes. Batteries in any backup pack are checked too.

Controls that have been under water

Makers of gas fireplaces are clear about water. Their manuals say not to use the fireplace if any part has been under water, and to have a qualified service technician inspect the unit and replace any control part and gas control that was under water.

Water can corrode the inside of a valve and its safety parts without any sign on the outside. Drying it out and trying it isn't worth the risk.

Our specialists identify every part the water reached and replace them with the maker's parts, then test the unit fully before it's used. The parts list is priced on the quote.

Smells that are normal and smells that aren't

A new gas fireplace, or one lit for the first time in months, can smell of hot paint or burning dust for a short while. Makers describe that as normal and advise ventilating the room until it passes.

A rotten-egg smell is different: that's the odorant added to gas, and it means gas is escaping. Manuals tell you to get out first and phone the gas supplier from outside, before touching any switch or control.

After the gas company has made it safe, our pros can check the unit and tell you which kind of smell you had and what caused it.

Free Inspection

Your gas unit, tested free

Thermocouple and thermopile readings taken at the gas valve
Inlet and manifold pressure against the rating plate
The safety barrier in front of the glass, and its condition
Anything that was under water, listed for replacement

Claim 10% off your first service

The first gas fireplace repair we make for you is 10% off when you book today.

Call (352) 675-6366 Get a Free Inspection

FAQs

Gas fireplace fixes, answered

Why won't my pilot stay lit?

The thermocouple or thermopile may be worn or out of the flame, or the pilot may be clogged. Our pros meter-test the sensors and check the pilot flame before replacing anything.

Is gas fireplace repair covered by a warranty?

The repair itself has our workmanship warranty, and new parts carry the maker's warranty under its terms. Reserve your free gas fireplace inspection in Lake Butler at (352) 675-6366.

Our Services