Gas fireplace repair around Starke, FL

Each repair begins at the switch and follows the maker's manual. Free inspection for gas fireplaces in Starke.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

A unit that shuts off mid-evening

Fireplace lights fine but goes out after twenty minutes or an hour? On a unit vented through a chimney, a spill switch near the draft hood may be shutting the valve because exhaust is spilling. On a direct-vent unit, a leaking or poorly pitched vent can starve the pilot.

Following the maker's troubleshooting steps through the switch, the vent and the termination shows why the unit is protecting itself. That shutdown is a safety feature, so it's fixed at the cause and left working. Ask our specialists about the shut-off problem in Starke at (352) 675-6366.

When the 2020 Census counted Starke, it found 5,796 residents. The Gulf and Atlantic shorelines are away from Starke.

What's Included

Switch, sensors, valve and glass

Pilots that drop out diagnosed with a meter
Logs reset to the maker's diagram
Barrier screens checked or added where offered
Gas conversions done with the maker's kit

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Power outages and electronic ignition

If a storm knocks out power to your home in Starke, a gas fireplace with electronic ignition may need battery backup to light. Weak backup batteries are a common reason it won't start when you need it. Our pros check the battery pack and receiver batteries on every service and show you how the manual says to light the unit during an outage.

How It Works

Tested before any part is swapped

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Gas fireplaces repaired to the manual in Starke

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

A local, family-run business that services the same fireplace year after year in Starke.

Your price, upfrontYou see the fault and the price for your gas fireplace in Starke before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

What a healthy flame looks like

Each gas fireplace manual describes, and in most cases pictures, how the flame should look once the unit has warmed up. Many log sets are designed with yellow, lively flames, and some burners show more blue, so the manual is the reference for your unit.

Our specialists let the unit run long enough to settle, then compare the flame with the manual. Soot on the logs or glass, flames lifting off the burner, or a flame much bigger or smaller than pictured all point to a cause.

From there, they check logs, burner ports, air shutter and pressure in turn, and record only what they've measured.

Vent problems that put the flame out

Direct-vent pipe is two pipes in one: an inner pipe carrying exhaust out and an outer one bringing fresh air in. If the inner pipe leaks, exhaust mixes into the fresh air and the pilot and burner can go out.

Maker troubleshooting sections also point to horizontal vent runs pitched the wrong way and termination caps installed incorrectly.

When a unit shuts down mid-burn, the vent joints, the pitch and the termination get checked against the manual. Fixing the vent fixes the outage, and any parts come from the vent maker's listed range for your system.

Remotes, receivers and wall controls

Many gas fireplaces run from a remote, a wall control or a smart module, talking to a receiver near the valve. Batteries sit in both the handheld and the receiver, and receivers have their own switch positions.

When the remote stops working, our specialists check both sets of batteries, the receiver's switch setting and its pairing with the handheld, then test the valve directly to see if the fault is in the control or beyond it.

A failed receiver is replaced with one listed for the valve, and you're shown the manual override for next time, so a dead battery doesn't leave you without a fire.

Free Inspection

Your gas unit, tested free

Thermocouple and thermopile readings taken at the gas valve
Burner ports, air openings and the control compartment
Glass, gasket and latches that seal the front
Vent joints, their pitch and the termination outside

Claim 10% off your first service

The first gas fireplace repair we make for you is 10% off when you book today.

Call (352) 675-6366 Get a Free Inspection

FAQs

Gas fireplace fixes, answered

Does the valve need replacing?

Only if testing says so. Maker troubleshooting charts have the valve replaced last, after the sensors and switch test good, and our pros follow that order with a meter.

How do you clean cloudy glass?

With the maker's glass cleaner when the unit is cool, since ordinary cleaners can bake on. Black soot means a flame problem, and our specialists find the cause as well.

Our Services