Service for gas fireplaces in Raleigh, FL

Won't light, won't stay lit or burns oddly? Local pros find the cause in Raleigh with a free inspection and the unit's manual.

Family owned and run
Free inspection first
100% satisfaction, guaranteed
Locally owned and operated

Call (352) 675-6366 Get a Free Inspection

Request a Free Inspection

Prefer the phone? Call (352) 675-6366

After a flood or water leak

Did water reach the fireplace, from a flood, a burst pipe or a leak above? Gas fireplace makers say not to use a unit if any part of it has been under water, and to have a qualified technician replace any control part and the gas control that got wet.

Every part the water reached gets identified and replaced with the maker's parts before the fireplace is used again. It's not a job for drying out and hoping. You'll see the list of parts and the price up front. Reserve a post-flood gas fireplace check in Raleigh by calling (352) 675-6366.

We cover Raleigh along with the rest of our Levy County area. In 2020, the Census Bureau counted 357 people living in Raleigh.

What's Included

Switch, sensors, valve and glass

Pilots that drop out diagnosed with a meter
Electronic ignition faults traced and reset
Valves replaced only when the readings say so
Fixes in Raleigh that our workmanship warranty stands behind

Call (352) 675-6366 Get a Free Inspection

Local Conditions

Lint and pet hair in Raleigh

Dust, lint and pet hair are the day-to-day enemies of a gas fireplace in Raleigh. They drift into the burner, the pilot and the air openings, and the flame changes. Our pros clean those areas on every service, following the maker's advice to check sooner in homes with pets. A clean burner can clear up a flame complaint with no parts at all.

How It Works

Tested before any part is swapped

Watch it and read the plate

Our pros see the fault happen, then read the rating plate and pull up your unit's manual.
Test from switch to valve

Switch, receiver, sensors and ignition are tested in order, with readings recorded.
Repair with listed parts

The failed part is replaced with the maker's listed part, or the cause is cleaned and adjusted.
Check the whole unit

Checks appropriate to the model are completed and explained before any further work is proposed.

Why Choose Us

Gas fireplaces repaired to the manual in Raleigh

Locally owned and run
A family-run company
100% satisfaction guarantee
Your inspection is free
Same-day visits available
Arrange a visit, take 10% off

Gas supply work is named on the quote for a gas contractor or your supplier in Raleigh.

Your price, upfrontYou see the fault and the price for your gas fireplace in Raleigh before any part is ordered.
Same-day service is availableSame-day repair visits are available when the schedule allows and the part is on hand.
Our workmanship warrantyNew parts keep the maker's warranty, and our workmanship warranty sits on the repair itself.

Call (352) 675-6366 Get a Free Inspection

Replacing the gas valve only when it's the cause

The gas valve is one of the costliest parts on a gas fireplace, and it tends to get blamed first. Maker troubleshooting charts put it last: the valve is replaced when the sensors read good and the switch circuit tests good, and the burner still won't come on.

With a meter at every step of that order, a valve is replaced only when the readings point to it.

When it is the valve, our pros fit the maker's listed replacement for your model and gas type, test it with a leak solution and set the pressures to the rating plate.

Cleaning lint from the burner

Lint, dust and pet hair drift in and settle on the burner, in the air openings and in the control compartment. Makers call for keeping those areas clean and suggest checking sooner in homes with pets.

Clogged burner ports and air openings change the flame, making it yellow and sooty or weak and uneven. Our specialists vacuum and brush the burner, the ports, the pilot area and the control compartment during a service.

It's simple work, and it fixes a surprising number of flame complaints without any parts at all. It's part of every yearly service. The service summary notes what was found in the burner.

Which noises are normal

Steel fireplaces tick and pop as they heat and cool, and makers mention it in their manuals as normal. A soft whoosh when the burner lights is normal too.

A rattle from the glass, a grinding blower, a loud bang on ignition or a new whistle isn't. A delayed ignition bang, where gas builds up before it lights, needs looking at soon.

Our specialists listen to the unit through a full cycle with you, from lighting to shutdown, and tell you which sounds belong and which point to a part that needs work. Each fix is priced before anything is replaced.

Free Inspection

Your gas unit, tested free

Shape of the pilot flame against the manual's drawing
Spark ignition, the flame sensor and any module lockout
Glass, gasket and latches that seal the front
The blower, its temperature switch and the fan wheel

Claim 10% off your first service

Warm evenings again in Raleigh? Arrange a visit and a first service call is 10% off.

Call (352) 675-6366 Get a Free Inspection

FAQs

Gas fireplace fixes, answered

Why won't my pilot stay lit?

The thermocouple or thermopile may be worn or out of the flame, or the pilot may be clogged. Our pros meter-test the sensors and check the pilot flame before replacing anything.

How do you clean cloudy glass?

With the maker's glass cleaner when the unit is cool, since ordinary cleaners can bake on. Black soot means a flame problem, and our specialists find the cause as well.

Our Services